My A button was requiring a harder press for the input to be registered than normal, so I opened up my GBC and noticed this transfer on the PCB. I guess years as a child hard holding A to improve pokemon catch rates had caught up. What’s the best way to remove this? Isopropyl alcohol and cotton bud?

  • j4k3@lemmy.world
    link
    fedilink
    English
    arrow-up
    10
    ·
    4 months ago

    The buttons use a carbon based compound to make contact. I think you’ll likely need to source a new button replacement. That is likely the carbon layer.

    In general, rubbing alcohol is the goto for cleaning on a PCB. I use an old ultrasonic toothbrush or regular old toothbrush if I can’t submerge whole boards in an ultrasonic cleaning bath.

    • Fecundpossum@lemmy.world
      link
      fedilink
      English
      arrow-up
      13
      arrow-down
      1
      ·
      4 months ago

      To clarify, you want 91% isopropyl alcohol. The normal 70% stuff used for first aid as too much water in it for use on circuitry. As far as application, you’re probably fine using a q-tip with light strokes back and forth.

      • TimeNaan@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        arrow-down
        2
        ·
        4 months ago

        Even 91% seems quite impure, it will leave a lot of residues on the board. Best to go with 99% IPA

        • mark3748@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          3
          arrow-down
          1
          ·
          4 months ago

          Alcohol is so hydroscopic that your 99% will be 91% pretty quickly after opening. 91% is fine, even 70% will do, it just takes a bit longer to evaporate.

          The “impurity” is straight up water.

          • TimeNaan@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            arrow-down
            1
            ·
            4 months ago

            It’s not straight up water. It’s water and other chemicals. These chemicals leave a residue that can be corrosive.

            Pure 99% IPA shouldn’t leave white traces on the board.