Does this hobby ever get easier or is it always like getting kicked in the nuts by Ronaldo?

Filament some how leaked up and burned on. I just don’t have it in me to keep tinkering. I just want to print

  • carl_dungeon@lemmy.world
    link
    fedilink
    English
    arrow-up
    21
    ·
    11 months ago

    I’m guessing you have a nozzle not screwed in fully, or there was filament above the threads preventing it from seating. I’d warm the print head, remove the nozzle, run a bit of filament through without the nozzle, then yank it out, hopefully pulling any globs down and out of the heater block. Reassemble hot and make sure the nozzle seats firmly. Good luck!

      • prime_number_314159@lemmy.world
        link
        fedilink
        English
        arrow-up
        13
        ·
        11 months ago

        It’s worth noting that some but not all combinations of heat break, nozzle, and heater block require re-tightening at the temperature used for printing. Basically, different metals expand different amounts when they’re heated, so if the block expands more than the other two, a gap will open up between them, and melted filament can find its way through.

        • Thanks4Nothing@lemm.ee
          link
          fedilink
          English
          arrow-up
          3
          ·
          11 months ago

          Yes and on some printers, that spot where the Bowden tube meets the nozzle is very problematic. You have to loosen the nozzle a bit, push the Bowden tub up against it, then tighten the nozzle the rest of the way

          It was awful on my Ender clone, but haven’t had that issue on my Prusa.