Printed with two PETG filaments on a glass bed with hairspray. Printed the black lines (with a custom end code that doesn’t turns off motors) then printed the white over it in a separate gcode (also with custom start with no homing). It even allows me to go with an exact and cut off hairs and blobs before laying the white. The. The two fuse on the same layer so the color isn’t sticking out.

  • LazaroFlim@lemmy.filmOP
    link
    fedilink
    English
    arrow-up
    4
    ·
    edit-2
    1 year ago

    I print the letters face down on the print bed with a first Gcode (make sure the geocode doesn’t stop the motors at the end). Then you print a second file over it for the plate that has a gap of your initial layer height where the letters are. The benefit is that if I fail a print, I only wasted on layer not a whole print.

    • MrSlicer@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      If you use something like tinkercad you can hold both objects in the same spot and export them one at a time. They will in turn populate the same position in cura.