I’ve been tuning to print at a 0.1mm layer height, the ironing turned out like this. The left side of the Z is a little textured and more shiny.

Why did this happen and how could I fix it?

  • moody@lemmings.world
    link
    fedilink
    English
    arrow-up
    12
    ·
    1 year ago

    Ironing is a 3d printing term where the heated nozzle is used to smooth the final layer, it’s not about taking an actual iron to your print.

    The print shown is a calibration cube, meant to show you the results of your print settings so you can adjust them to get better prints.