Got an anycubic resin printer and I’m using their high speed resin (because it was bundled for free), and i tried to send a file using the high speed setting.

After the print it was seemed to be ok, then after i left in a bath of ethanol (IPA can’t be found in stores in my country) i got all those holes.

What’s the problem?

A slicer problem? The ethanol bath? The high speed resin that’s not good?

  • eyes@lemmy.world
    link
    fedilink
    English
    arrow-up
    11
    ·
    edit-2
    7 months ago

    Ethanol should be fine to use as far as I know. Do the holes go all the way through? If so your screen might have dead spots. You can visually inspect the screen by setting it to do a test exposure without the resin tank on it to check. Also obviously check that your tank doesn’t have any failed print bits stick to the sheet.

    • Moonrise2473@lemmy.mlOP
      link
      fedilink
      English
      arrow-up
      6
      ·
      7 months ago

      visual inspection of test exposure is ok, and then the vat is brand new so the sheet was immaculate

      • eyes@lemmy.world
        link
        fedilink
        English
        arrow-up
        7
        ·
        7 months ago

        Is this the first print you’ve done with it? Have you done any exposure calibration with this resin?

        • Moonrise2473@lemmy.mlOP
          link
          fedilink
          English
          arrow-up
          5
          ·
          edit-2
          7 months ago

          first print with the printer and first print with resin in my life

          The manual didn’t mention the exposure calibration at all…

          • eyes@lemmy.world
            link
            fedilink
            English
            arrow-up
            9
            ·
            edit-2
            7 months ago

            It’s probably under exposed then. Something like this and this will help you tune your slicer settings. You might need to play with other settings if you have other issues, but most of the time the exposure settings will be the problem with new resins.

            • PipedLinkBot@feddit.rocksB
              link
              fedilink
              English
              arrow-up
              2
              arrow-down
              1
              ·
              7 months ago

              Here is an alternative Piped link(s):

              this

              this

              Piped is a privacy-respecting open-source alternative frontend to YouTube.

              I’m open-source; check me out at GitHub.