Is there a bad taxidermy community?
Is there a bad taxidermy community?
I might have crossed my wires, it was probably just a forum post I misread. I happened to have new ceramic burrs so I went ahead and installed them.
I got closer to a perfect pull this morning after adjusting the right lever! Unfortunately I’m out of that coffee now so the process restarts with the next bag.
New ceramic burrs.
I typically use light roast beans, apparently ceramic is better there.
Went through the hyperalignment procedure and got close but not perfect. Had to move on and get it back together at some point.
Works the same, just inline. And this grinder has two
Me writing my resume in third person
Me, spending hours on Age of Empires 2 and loving it
This is how I did it with my old board. My new board has a jumper to toggle between powering via USB and not.
When the only tool you have is a deep lifelong understanding of computational language, everything starts to look like a hypergraph.
It’s a joke about software development tools breaking in dumb ways, and that it’s not a problem with saws
I’m a software engineer who does woodworking, and I approve this message.
But my favorite explanation: you grab your hand saw, and it works. You don’t find out that the latest npm japanese-hand-saw-tooth package is incompatible with plywood, and you need to downgrade the package or buy new plywood to make a cut.
This should be a Will Ferrell movie
You can already do this at Gene and Jude’s
I want to see how big their bottle of Titebond III is.
The only thing spicy in Ukraine is horseradish
I can barely code fibonacci, doubt I could model it
Ender, prusa, bambu are names that have popularity, longevity, and reputation.
You can find a ton of recommendations and best printer lists with a quick search. You would probably be fine with most printers on those lists if you wanted to save some money, but the above three are solid and give you a good budget range already.
There’s a little bit of movement but it’s not too annoying. When loaded up with belts, taking one off doesn’t make a big difference.
My personal solution was to not own any. But I have thought about it. Maybe a slot on both ends of the body to slide the knob of the buckle into. That would allow for two belts pretty easily.
Try to go with something popular so you can find help when things inevitably go wrong. Expect to learn a lot when building. If you like that, awesome, do it. Otherwise you may want to consider a prebuilt prusa or bambu.
Why can’t they use the excess energy to make the train go again?