Big recommend to just jump straight to OrcaSlicer. It has Bambu Studio’s much-improved-over-PrusaSlicer UI but with features ported in from PrusaSlicer and SuperSlicer and compatibility with non-Bambu printers.

This is fantastic. Is the file hosted anywhere?

This is definitely not true of OrcaSlicer, at least not anymore. I’m running an 0.6mm nozzle and 120% layer width at 0.2mm layer height results in 0.72mm line width, not 0.24mm.

Another OrcaSlicer user here. Started off with PrusaSlicer and switched over at a friend’s recommendation, and honestly am so glad I did (it has a much nicer UI and some really neat features ported over from SuperSlicer).

These look great! Can we get a link to the design, please?

EDIT: nvm, found it!

Thanks, and good luck! In Orca, I set it to all walls fuzzy, 0.5mm between points, and 0.2mm depth, and I like the results.

Thanks for showing us this! I printed one with “fuzzy skin” and it is so cool (unfortunately doesn’t show up well in photos though).

SV06 Plus, SV07, and SV07 Plus all use the same nozzles. However, I think standard volcano nozzles would also work – I just haven’t bothered to try since I bought a five-pack of the proprietary nozzles off AliExpress and they work perfectly fine.

Yes, adaptive cubic varies the density of the cubic structure to decrease filament usage while supposedly maintaining the same strength as normal cubic. And, in my own experience, gyroid always takes longer to print than adaptive cubic – sometimes it only adds a few minutes, but I’ve seen it add nearly half of the print time again for infill-heavy prints.

I just wish it didn’t take so much longer to print than adaptive cubic at the same infill percent.