• 0 Posts
  • 2 Comments
Joined 1 year ago
cake
Cake day: July 7th, 2023

help-circle
  • Temperature: Bump your temperature up 10 degrees and see if it changes, if you have a thermometer check if your heating block to see if it is actually at the set temp.

    Tension: here’s a good article about it

    https://filament2print.com/gb/blog/141_3d-printing-extrusion-systems.html

    Though looking at your video again, it looks like it’s gripping, but the wheel isn’t spinning. This is what’s leading me to something not allowing it to pass through the nozzle. If that wheel isn’t spinning, then it’s probably not an inability to grip but the stepper motor skipping because it can’t push the filament through the nozzle for some reason.

    If your temps seem to be calibrated properly next step I would take is to remove your nozzle (while hot) and see if filament is able to be pushed through.