minus-squareIAmDotorg@lemmy.worldto3DPrinting@lemmy.world•Have you ever seen this type of print failure?linkfedilinkEnglisharrow-up1·11 months agoThat looks like Capricorn tubing. It’s got a 1.8mm, not 2mm, inner diameter. I used to regularly run into cheap filament that varied up close to 1.8mm in diameter that would get jammed in the tubing. When I did, tossing the roll was my only option. Capricorn is great for reducing filament backlash and printing flex, but requires very consistent filament. linkfedilink
That looks like Capricorn tubing. It’s got a 1.8mm, not 2mm, inner diameter.
I used to regularly run into cheap filament that varied up close to 1.8mm in diameter that would get jammed in the tubing.
When I did, tossing the roll was my only option.
Capricorn is great for reducing filament backlash and printing flex, but requires very consistent filament.