I want to set up a VPN that uses the client’s IP when sending data out of the VPN server. I am able to use either OpenVPN (open-source edition), or Wireguard.
I want to set up a VPN that uses the client’s IP when sending data out of the VPN server. I am able to use either OpenVPN (open-source edition), or Wireguard.
That’s not true. There’s an infinite numer of ways to route IP addresses on the internet in fact. Most of them are useless however.
Mission accomplished? This may be what OP wants? Really not sure.
I think what they were trying to say is that packets are usually routed one particular way, which is true (routes normally don’t suddenly change unless there’s a major change like an outage or cost change). This part of their comment makes me think they do understand that there’s many possible routes:
Yeah, I almost talked about anycast IPs but it just added unnecessary complexity.
OP’s question is a bit weird but it sounds like they want to connect to a VPN server and then that server uses the client’s IP instead of its own for outbound traffic, like some sort of forwarding?
For all I know OP may be asking for a bridged VPN and it really just means to forward the remote client as if it’s on the local network.
But the way it’s worded, the same IP would be used to both talk to the server and by the server itself going outbound. It’s possible on a local network with iptables hacks but why would you even want to do this?