I’m planning on building a new gaming PC in the next couple of months. I haven’t done so in about 7 years, so I’m a bit behind the times on hardware. Is there any special considerations you all would recommend when it comes to gaming on Linux? I already run Linux as my daily driver and have a home server, etc, so I’m mainly looking for suggestions regarding current hardware that I would want to consider for my new build.

I haven’t done so before, but I’m interested in running Windows in a QEMU VM to avoid some of the pitfalls for certain multiplayer experiences in certain titles. If anybody has any experience with this also, I’d love to hear about it!

Thanks for any input you all have!

  • hallettj@beehaw.org
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    I think one of the most impactful choices in my last build was choosing a fast SSD. Not all SSDs are the same! Nowadays you can get NVMe drives that operate over PCIe instead of SATA which provide much higher throughput.

    You can either get an M.2 form factor that plugs into a special socket on the motherboard and takes up minimal space, or a PCI card that plugs into the same type of slot as a graphics card. (Note that some M.2 drives / sockets are SATA, not NVMe, so watch out for that distinction.)

    There is also some difference between NVMe implementations depending on which PCIe version they support. And you’ll want a motherboard that implements the same PCIe version. This applies to both M.2 and PCIe SSDs.

    This stuff might be old enough that you’ve already encountered it. But it was new to me when I built my last PC in 2020. Other than that building was pretty much as I remembered from previous decades.

    • poVoq@slrpnk.netM
      link
      fedilink
      arrow-up
      3
      ·
      1 year ago

      GPUs got a lot bigger and more power-hungry. So you need to check the PSU and it’s 8/16 pin GPU connector as well as space in the case.

        • poVoq@slrpnk.netM
          link
          fedilink
          arrow-up
          2
          ·
          1 year ago

          I was a bit confused reading your comment, given that the vast majority of the world has 220V everywhere 😅

          But actually a ATX PSU steps down the the power to 12V anyway, so I doubt 110V or 220V makes much of a difference.

          • Cole@midwest.socialOP
            link
            fedilink
            English
            arrow-up
            1
            arrow-down
            1
            ·
            1 year ago

            Supposedly 220V is a little more efficient to step down than 110V? I’ve read a lot of articles about data mining where they run the mining rigs off of 220V in the USA instead of 110V and they gain something like 5% efficiency. They’re doing it with entire shipping containers full of PCs though. On my single PC, I’m not sure I can tell the difference at all. But I’m an Electrical Engineer by trade, so it makes me feel better that I’m more power efficient and have my panel balanced. I was running the 220V for my server rack anyway, so it wasn’t a lot of effort to pull one more circuit for my Desktop PC.

    • Cole@midwest.socialOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      My existing PC is old enough, it only has the SSD. I’m really looking forward to the NVMe drive after all the comments!