Grab your best lube, because it’s time to talk about fluids!

  • BarbecueCowboy@lemmy.world
    link
    fedilink
    English
    arrow-up
    9
    ·
    4 months ago

    I know I’m likely alone, but I’m actually kind of bummed on this change.

    The old fluid system is janky and unpredictable and I have other complaints, but the way things flowed was sometimes part of the fun. I’ll kind of miss the puzzles of ‘Why are my flamethrowers not working again?’

    • joelfromaus@aussie.zone
      link
      fedilink
      English
      arrow-up
      6
      ·
      4 months ago

      I somewhat agree. When it worked it was truly fun to see in action. Alternatively, when it didn’t work (due to reasons mentioned in the FFF) it’s was quite frustrating.

      All in all I think it’s a step that had to be taken though I’ll definitely miss the old systems quirks.

    • Contramuffin@lemmy.world
      link
      fedilink
      English
      arrow-up
      4
      ·
      4 months ago

      I can kinda see both ways. I think both systems aren’t necessarily mutually exclusive - I think the old system works more intuitively for pipes with low volumes of fluid, and the new system works more intuitively for pipes that are full or near full.

      I hope that the developers can mix the two systems, so that pipes function with the old system when pipes are empty or near empty, and it switches to the new system when pipes are full or near full

  • wirelesswire@kbin.run
    link
    fedilink
    arrow-up
    5
    ·
    4 months ago

    I knew there was some jank with the fluid system, but not to this degree. I now feel less bad about leaving some pipe setups in a “good enough” state instead of optimizing.

  • key@lemmy.keychat.org
    link
    fedilink
    English
    arrow-up
    3
    ·
    4 months ago

    Oh wow I didn’t realize nearly any of that detail about the current system. That explains why my fluid systems would always be unbalanced crap and sometimes require inexplicable pumps be added.

  • Lojcs@lemm.ee
    link
    fedilink
    English
    arrow-up
    3
    ·
    edit-2
    4 months ago

    I liked the previous system more than this. I think they could easily have the best of both worlds by making each pipe its own segment that pulls fluid from segments that have less fluid in them proportional to how much fluid that segment has. That way there’s both a propagation lag (and closer buildings getting more throughput than farther ones) like the current system and high throughout if the entire pipe is filled like the new system. This even opens up the possibility of higher quality pipes forming larger segments to increase throughout when the pipe isn’t fully filled.

    This would cause sloshing, but that can be fixed by each segment checking if the segment they’re pulling from pulled from them last tick and if so temporarily combining into a single segment for the next tick.

    The evaluation order feels tricky for this to work and the fill amounts of the segments would need to be updated right after evaluation instead of at the end of the tick for full throughput, but I think that can be figured out

  • Lvxferre@mander.xyz
    link
    fedilink
    English
    arrow-up
    1
    ·
    4 months ago

    I’m not currently playing the game (lots to do and, well… it’s Cracktorio, you know), but I’m wondering about the impact of those changes on my typical playstyle. It’ll be probably neutral or positive.

    The key here is that I only use the fluid mechanics for short-range transportation, and even then I’m likely to force a priority system through pumps; in the mid- or long-range, I’m using barrels all the time, even for intermediates.

    Perhaps those changes will force me to revaluate the role of pipes, that would be a net positive. If they don’t, the changes will be simply neutral.