Tesla is facing issues with the bare metal construction of the Cybertruck, which Elon Musk warned was as tricky to do as making Lego bricks

      • curiousPJ@lemmy.world
        link
        fedilink
        English
        arrow-up
        11
        ·
        1 year ago

        The total tolerance is .0004". In equally disposed bilateral tolerancing it will be ±.0002".

        • AlDente@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          4
          ·
          1 year ago

          Eh, if someone tells me to reduce a tolerance from 5 to 10 thou at work, it’s understood that it’s +/-5 and 10. I don’t think I’ve ever heard someone use the full range of a tolerance in conversation. If the tolerance isn’t bilateral, it would be said like plus 5, minus zero. Anyways, +/- .0005" is our standard tolerance on the span of all dowel hole pairs.

          • curiousPJ@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            ·
            edit-2
            1 year ago

            Bilateral tolerancing is a Machinist’s first introduction to tolerancing so it’s no surprise to run that as default. And I suppose GD&T is not heavily used where you are.

            If you’re given a parallelism tolerance of 10 micron are you assuming that to be ±10 micron? True position? Angularity of 5 thou? Etc… The only feature control that could be interpreted as bilateral by default is profile and it’s still communicated by its total tolerance.

            Simple ± tolerancing isn’t the industry standard anymore. And if Tesla prints are anything like spaceX ones… It’s basically all GD&T and minimal title block tolerances.

            • AlDente@sh.itjust.works
              link
              fedilink
              English
              arrow-up
              1
              ·
              1 year ago

              I use GD&T on all my drawings, including 100% of my hole callouts. However I’m one of the more enthusiastic adopters of ASME Y14.5 at the place I work. Therefore, I get what your saying regarding the tolerance range, but since most of my coworkers are still relying on block tolerances, I’ll refer to a .010" positional tolerance as a “+/- .005” equivalent" in conversation so there is no miscommunication. I can see how this is not the norm.